10 To enable RIP routing for a specific subnet, the configuration command network 172.16.64.32 was entered by the network administrator. They automatically switch the path to the destination network when the topology changes. They take less time to converge when the network topology changes. They improve the efficiency of discovering neighboring networks. 9 Compared with dynamic routes, what are two advantages of using static routes on a router? (Choose two.) It is identified by the prefix C in the routing table. It is unaffected by changes in the topology of the network. It is automatically updated and maintained by routing protocols.* What error has been made in the static route configuration?Ĩ Which statement describes a route that has been learned dynamically? After the static route command is entered, connectivity to the network is still failing.
An administrator is attempting to install an IPv6 static route on router R1 to reach the network attached to router R2. Which command will implement a backup floating static route to this network? Which route was configured as a static route to a specific network using the next-hop address? It is configured with a higher administrative distance than the original dynamic routing protocol has. It identifies the gateway IP address to which the router sends all IP packets for which it does not have a learned or static route.* It uses a single network address to send multiple static routes to one destination address. It backs up a route already discovered by a dynamic routing protocol.
To prevent the router from joining the all-routers multicast group 3 What is a characteristic of a static route that creates a gateway of last resort? To permit only unicast packets on the router To assign the router to the all-nodes multicast group Source IP: 10.1.1.1 2 What is the effect of configuring the ipv6 unicast-routing command on a router?
What will be the source MAC and IP addresses on the packet when it arrives at host B?
CCNA 2 v6.0 Final Exam Answers Routing and Switching Essentials (Option B) 1 Refer to the exhibit.